Eastwood Pro Former Tubing Bender
The Eastwood Pro Former Tubing Bender lets you bend steel and chrome-molybdenum tubing in diameters from 0.75 inch to 1.75 inch. It is a good fit for small shops building custom tube cross members, transmission mounts and other tube components.
A ridged steel frame and an 8 ton forming jack give a sturdy base that stays put on the bench during use. Steel forming dies and cast followers produce accurate bends without flattening or deforming the tube. The kit arrives with dies for 0.75, 1.0, 1.5, 1.625 and 1.75 inch tubing along with a complete instruction manual.
The bender handles mild steel and chromoly across a range of wall thicknesses. If you need a bend greater than 90 degrees or a 90 degree bend in heavier wall tubing, you can bend two pieces at smaller angles and weld them together.
What's Included:
- Pro Former tubing bender with ridged steel frame
- 8 ton forming jack
- Forming dies for 0.75", 1.0", 1.5", 1.625" and 1.75" tubing
- Cast steel followers
- Instruction manual
Specifications
- Tubing diameter range: 0.75" to 1.75"
- Included dies: 0.75", 1.0", 1.5", 1.625", 1.75"
- Forming jack: 8 ton
- Frame: Ridged steel construction
- Followers: Cast steel
- Material compatibility: Mild steel and chromoly tubing
- Mild steel, 60 degree bend: 0.75" to 1.75" diameter, 0.049" to 0.090" wall
- Mild steel, 90 degree bend: 0.75" and 1.0" diameter, 0.049" to 0.090" wall
- Chromoly, 60 degree bend: 0.75" to 1.75" diameter, up to 0.040" wall
- Chromoly, 90 degree bend: 0.75", 1.0" and 1.5" diameter, up to 0.040" wall
